Exposed plywood edges on trailers and ramp doors can wear down, splinter, or absorb water over time. This aluminum angle trim covers the edge to protect it and create a clean, finished corner.
If you're replacing worn trim or finishing exposed plywood edges, getting the right size and profile matters. Uneven angle means the two legs are different lengths. This angle trim is not trailer-specific. To get the right fit, you'll need to match it to your existing trim by measurement. If you're replacing a section, measure your current trim and compare:
The shape matters just as much as the dimensions. If the profile doesn't match, the trim may not sit flush or fully cover the edge. Even small differences can prevent the new piece from lining up with your existing trim. If you're not sure, take a few measurements and photos of your current setup and reach out to etrailer support for help comparing options.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone, Steve here with etrailer.com. Today we're looking at our P and F products angle trim for your enclosed trailers in aluminum. As you know, angle trim will cover any exposed plywood edges on your enclosed trailer. It can be used inside your trailer or on your trailer's ramp door. It's an aluminum construction so it's not gonna rust or corrode. You can cut it to length.
It does come 93 and one half inches long. It's about three quarters of an inch wide there on that flat, shorter length, and then it's about one and one half inches wide on the long end there. And it's almost one eighth inch thick, not quite. Well folks, that is gonna wrap it up for our look together. I'm Steven, thanks for watching.
.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.